1. The deformation of wood
Solution: The main materials used for decoration, particularly wood, should be placed for
three to five days indoor with heating devices, in order to volatilize moisture produced
due to temperature changes. This is to make the moisture contained near the house level,
to avoid deformation of wood after renovation.
2. Veneer cracking
Solution: After the decorative panels transported to the site, use dry towel to wipe
dust, brush varnish twice to cover the back. All decorative panels should be flat, with a
block-board in the bottom and above. It could not be stand, so as to prevent panel
cracking or becoming warped.
3. Wall cracking
Solution: Painting when putty does not dry, the wall is easy to "sweat" and even appear a
big area of cracking phenomenon.
from 10 am to 4 pm. This period the temperature is relatively higher, can prevent the
freezing of the new batch of putty. After the first putty is completely dry, then award
the second time. Until it is completely dry, then carefully polish it with sand paper.
4. Gypsum-line cracking
Solution: When carry out the gypsum board ceiling, the moisture of the bilge keel must be
controlled below 12%, and the bilge keel must be strong, to prevent cracks in gypsum
board ceiling. The joints between the gypsum board, gypsum board and the wall should be
left out of about 0.5 cm gap. Caulk the gap with the gypsum powder and latex, and then
double-paste kraft and apply putty to prevent gypsum line cracking.
5. Paint ineffective
Solution: If you encounter windy or cool weather, not to work with the oil, because of
the large winter wind and sand, it’s easy to adhere dust when wet. You also should
ensure that the temperature of coating applying is above five degrees Celsius, and the
temperature of varnish applying is above 8 degrees Celsius. In a word, you should be
seriously accordance with the product description. To prevent the sand falling on the
surface of paint, doors and windows should be closed.
6. Improper seam
Solution: winter decorations, the seam of doors and windows should not be too small to
avoid the summer heat expansion and tight. If applying the solid wood floor, About 2 mm
expansion joint around should be left. When making furniture, you also need to set aside
about 0.1 mm interface seam. With the floor layering forming the transition can better
deal with the state of too much seam between the floor and wall joints.
7. Ceramic tile shedding
Solution: In winter, geostrophic and ceramic tile should be dipped in water before the
pavement, and it should reach saturation. In addition, both the geostrophic and ceramic
tile should be used after moving indoors from the outdoors 24 hours, when they have
adapted to the indoor temperature, in order to avoid hollowing and shedding phenomenon.
Brick paving should be followed by pointing a timely manner.
Seven Practical Solutions for Decoration in Winter